Technics RS-TR474

“During recording, press I
on Deck 1.
(Deck 1 will stop, and Deck 2 will
record a 4-second silent interval and
then enter the recording standby
mode.}
: 2 Operate Deck 1 to find the track you
| wish to record.
It is aiso possible to change the playback tape at ‘his
time.
The TPS function is useful for finding the beginning of
the track.
(Refer to page 17.)
3 ““syucso "Press SYNCHRO START. _
! (Recording will resume.)
To cut unwanted parts during _
recording _ a
(Deck 2, which was recording, will
enter the pause mode. and Deck 1 will
continue playback.)
to record]
Press Ul.
(Deck 2 will resume recording.)
To stop recording
Press Mf on Deck 2.
(On Deck 2)
Your attention is drawn to the fact that recording pre-
recorded tapes or discs 01 other published or broadcast H
material may infringe copyright laws. I
i 1 Press El during fecording. — 7
For your reference:
The recerding level and the Dolby effect will be recorded as
they are on the tape being played back.
* Because the signal being recorded from Deck + onte Deck 2
does not pass through the amplifier, it is possible to change the
setting of the amplifier's input selector during recording in
order to listen to some other sound source.
When recording with the recording speed set to double speed,
noise interference may be recorded onto the tape if there is a
televisio: set nearby. so maxe the recording in a location
separated from the television set or switch off the television set
during recording.
~"[TWhen Deck Tt reaches apart you wish ~~