Technics RS-TR474

Either normal, CrO, or metal type cassettes can be used.
Use Deck 2 to record the sound dDeing played back on Deck 1.
es
Preparation
1. Switch on the power.
2. Load tapes which have been advanced to the end of the
leader tape into both decks.
Deck 1: For playback Deck 2: For recording
1 "Reverse Press REVERSE MODE to
f select the desired reverse
at mode.
nnn man ay
uu
wud
Each time the button is pressed, the in-
dicator will change in the order:
ate oO r eO.
a
=” : Only one side of the tape will be
recorded, and then operation
will automatically stop.
¢*D: Both sides of the tape (first the
forward side and then the
reverse side) will be recorded,
and then operation willl
automaticaly stop.
lf the recording tape is longer
than the playback tape, the
playback tape will be played
repeatedly as many as eight
times until the recording tape is
finished.
<x: Both sides of the tape (first the
forward side and then the
raverse side) will be recorded
once, and then operation will
automatically stop.
To record an only one side of the tape, set the tape side in-
dicators (<] or >) on Deck 1 and Deck 2 in accordance with the
tape sides to be played back and recorded.
To record on both sides of the tape, set the tape side indicators
on both Deck 1 and Deck 2 to the forward side (D>).
Press SPEED to select the
recording speed.
mad = ago
te mt aur ut
Each time the button is pressed, the in-
dicators wil! change in the order:
x1 +1 x2) > off
x1: Norma! speed
{x2 Double speed
are Press ATC.
{The ATC function will enter the stand-
by mode.)
{
(ann = mm Hi “GP
\
|
p
meus “ ui
\ vs
a eS |
Press SYNCHRO START.
(ATG will begin, and when it is com-
pleted, recording will begin}
(The recording will begin )
In order to avoid operation errors later, be sure to switch OFF
the SPEED button (the “> 1" and '* x 2!" indicator will go out}
after the tape-to-tape recording has finished.