Technics RS-X102 - Page 5

RS-X102
Mi DISASSEMBLY INSTRUCTIONS
“ATTENTION SERVICER”
Some chassis components may have sharp edges. Be careful when disassembling and servicing.
Ref. No.
2
i
NO;
|
Removal
of
the
cabinet
Removal of the front panel ass’y |
Procedure Procedure
«Remove the 6 screws (O~@).
Ref. No.
3
Procedure
1-2-3
Removal of the main P.C.B.
Rear panel
Front panel ass’y
2. Remove the 2 connectors (CP1, CP2).
3. Remove the 5 flat cables (CN3, CN4, CN5, CN6,
CN8).
4. Remove the front panel ass’y in the direction of
arrow.
How to remove the flat cable
¢Pull out the flat cable while 1. Lift the connector.
pressing the connector. 2. Pull out the flat cable.
(CN3, CN5, CN8) (CN4, CN6)
Pa
Flat cable
5
My Connector
, Ole at
Connector
2. Remove the 5 screws (O~@).