Technics SA-5060 - Page 2

B LOCATION OF CONTROLS
CAUTHES DO ROT REMI SCREWS LEC EPT
SE? AUTIOM WEHCL :
@ SIGNAL METER TAPE MONITOR PUSH SWITCH (@ FM ANTENNA TERMINALS...752
@ FM STEREO INDICATOR @ SELECTOR SWITCH (8 FM ANTENNA TERMINALS...3002
@ POWER SOURCE PUSH SWITCH @ TUNING CONTROL AM ANTENNA TERMINAL
@ HEADPHONES JACK @ GROUND TERMINAL PHONO INPUT TERMINALS
(6) BASS CONTROL (@ TAPE DECK CONNECTION TERMINALS @) AUX INPUT TERMINALS
© TREBLE CONTROL ( AM FERRITE ANTENNA COIL @ CIRCUIT PROTECTION FUSES
@ BALANCE CONTROL VOLTAGE ADJUSTER @ SPEAKER TERMINALS
VOLUME CONTROL Set for [X], [XG], [XGH], [XE], [XSD] REC/PLAY (DIN) SOCKET
@ LOUDNESS SWITCH | and [XSW]
P.T. Loch. POWERIC. Roh.POWER |.C. AM/FM IF AMP I.-C.
I CIRCUIT
~ op Se Rk & ow
&
Lat
AC
FUSE
POWERSOURCE
MPX
IC.
EQUALIZER
IC.
M@ DIAL CORD INSTALLATION GUIDE
1. Dial cord length is 195cm ( 76-7/8”).
2. Tuning gang is positioned at maximum capacity.
Pointer (Frequency is minimum)
3. Arrow marks (1~9) indicated correct order and
direction of stringing dial cord.
3 Turns
&
Tuning Shaft
SA-5060