Technics SC-CH404 - Memory Presetting: Manual Tuning

A,- ■ V,’
Memory presetting
Manual memory presetting
This feature allows you to manually preset stations into any desired
channel.
|;=e-
3
11. _. i.J, 1
0
1 _ 1 _
C_ LD
4
This example shows how to memorize FM 88. 10 MHz into preset
channel 1 .
Press TUNER/BAND to selec
FM or MW or LW.
Each time you press TUNER/BAND
“FM”, “MW”, "LW” will appear in order.
2
Press A or ▼ to tune in to th€
desired broadcast.
OU4TOUW
I ™ Op m »
[r i / u u. i u*'*
vouan MQLTl CO WTaOL
A ""TUTWWC
Press SET momentarily.
cum
C M p P 111
iii OLJ. 1
-c« .*oiMuw.nco«wH.
. ■ tuaan
5 Press ^ or ► to select the de-
^ sired preset channel.
Flashes.
1
ojhbzvx
cm on in
i n O O. i <_/—
1 «u«l COWTWOL
< ^-mu
1' M«UI
M + .m.
Illuminates.
Automatic scanning:
change**^ h ° ld A ° f T until the dis P [a y ed frequency begins to
•The changing of the displayed frequency will automatically stop if a
broadcast station frequency is located during the tuning process
•When there is excessive interference, the automatic scanning mav
not function. 1
To cancel the automatic scanning, press A or ▼ once again.
To preset FM stations in monaural position:
1. Select the desired frequency.
2. Press FM MODE on the remote control to show “MONO”.
3. Follow the procedure 3-5 above.
About the frequency step:
Each time you press A or T, the frequency display will change as
follows:
FM: 0.05 MHz step
MW: 9 kHz or 1 0 kHz step
(To change the MW allocation, see paqe 24.)
LW: 9 kHz step
5
Press SET momentarily,
MEMO indicator will go out.