Technics SC-CH404

To use the sleep timer
You can use this timer function to switch the power to the standby
mode at a specified time (within a range of 1 minute to 120 minutes
from the present time).
CLOCK/
TIMER
1
( 0 + ® ) (
■ »(SET^ ^
The following example shows how to set the system to standby mode
after 30 minutes.
CLOCK/
TIMER
*
While enjoying the desired source:
©Press CLOCK/TIMER four
times to select SLEEP.
SLEEP
Within 7 seconds:
© Press SET.
O<£>oo1"
ooo
oooo
oooo
oooo
oooo
oooo
oooo
o o
CD CD
O
CLOCK/
TIMER
To confirm the time remaining
on the sleep timer:
Press CLOCK/TIMER four times.
To change the time setting while sleep timer Is
functioning:
Follow procedure from the beginning.
If you want to operate the system again on the
same sieep time:
Press SLEEP on the remote control to show ■ 'SLEEP” on the display.
® Press ^ or ► to select the
^ O desired length of time.
©Press SET.
Please confirm SLEEP appears on
the display.
SLEEP
To cancel the sleep timer
mode:
Press SLEEP to go out the SLEEP on the
display.
The time setting will remain In the unit’s
memory.
46