Technics SC-CH404

Recording from compactdiscs
Synchro recording
You can use normal, chrome, and metal tapes for recording.
2 85 1
Check that the tape’s erasure prevention tabs {see page 53) are
intact, and then insert the cassette into deck 2.
The leader tape must be wound on beforehand. (See page 30.)
Press ^ OPEN to load a cas¬
sette In deck 2.
Press CLOSE on deck 2 to
close the cassette holder.
Press DOLBY NR so that the
DOLBY NR IN Indicator lights.
DOlBrNR
anaji,
0 - 0 -
9 7
[ -
Q O
_i J
dI
O o
o
^ J
i-ioo: (3-
Lr
-SKIP/-SEARCH ___
o O LJ
Set the tape travel direction.
To change the tape travel direction, first
press < or > on the cassette deck, then
□ .
Press A OPEN/CLOSE to load
a disc and then press It again.
Press REC PAUSE.
The cassette deck will enter the record¬
ing standby state.
Press > on the compact disc
player to start recording.
The recording will automatically start cor¬
responding to the tape travel direction
indicator.
o-o-o
5
Press REVERSE MODE to se¬
lect the reverse mode you
want to use.
ZH : One side will record, and
then the tape will stop au¬
tomatically.
CtD : Both sides will record (for-
CO ward side/reverse side),
and then the tape will stop
automatically.
Press CCRT to activate the
CCRT function.
You can record without using the CCRT
function.
To stop recording:
Press □ on the cassette deck.
After the compact disc play finishes:
The cassette deck will create a non-recorded passage of about
4 seconds, and then go into the recording standby state.
When you want to cut an unnecessary track while
recording:
Before an unnecessary track play will start:
1. Press DQ.
The cassette deck will create a non-recorded passage of about
4 seconds, and then go into the recording standby state.
2. Press km/-« or **•/ ► « to skip to the desired track.
3. Press > on the compact disc player to resume recording.