Technics SC-CH404 User Manual

Linking up several discs (LINK)
You can link up another disc when LINK indicator flashes after
editing a compact disc.
.. z- urn
O Ctt .T-iPt —
:• (_ 1
TT- 1 1 1
0 *j
Press A OPEN/CLOSE to re¬
place the disc with another
disc, and then press It again.
The time remaining on tape
E H3 IE S E
E E tE 52 52 i—it
22 a
r i—
_ 'Ll
p ■ u O l
' C" ‘ O
UN (SC
Lights.
2
Press D> to start recording.
The recording will start with the same
editing mode of the first disc.
The system will assign tracks to be re¬
corded on the remainder of the tape and
display the results.
Tracks to be recorded on tape side B
The recording will start after the system
completes the ATLS (see “One-touch
editing operation” on page 33) setting.
To specify the tracks to be edited:
1. Replace the CD.
2. Press PROGRAM on the remote control, and specify the track
number you want to record using the program play procedure.
3. Press > to start recording.
To record from the same disc in succession:
1. Press PROGRAM on the remote control, and specify the track
number you want to record using the program play procedure.
2. Press > to start recording.
Notes
•When you record the first compact disc using LAST FADE, tracks
to be recorded will not be displayed. However, it is possible to
record from another disc.
•When the display shows “0:00”, you cannot record from another
disc. Press □ to cancel the edit mode.
• If the time remaining on the tape is shorter than the length of the
tracks to be recorded, you cannot record the tracks. Replace the
disc with the tracks shorter than the time remaining on the tape or
press □ to cancel the edit mode.
3
Repeat steps 1-2 to record
more discs.

Technics SC-CH404 Specifications

General

Brand	Technics
Model	SC-CH404
Category	Stereo System
Language	English