Technics SC-CH404 User Manual

One-touch editing preparation
To start one-touch editing
You can use normal, chrome, and metal tapes for recording.
Press ▲ OPEN to load a cas¬
sette in deck 2.
When the edit-record will start, the ca-
sette tape will automatically rewind the
tape back to the beginning where the
recording can be made. So you don't
have to rewind the tape in advance.
Press CLOSE on deck 2 to
close the cassette holder.
There are 3 types of one-touch editing.
Be sure to finish the procedure of “One-touch edltina pre¬
paration” on the left. M K
..r- " ■ ) rm
:• t j »o
J.RT ALBUM LASTFADE
o o o
Editing of all tracks in their original sequence
(ALBUM)
oo CD
ALBUM
%
Press ALBUM.
The tracks assigned on tape side A
Ugh
ts.
9
L2
v t\l. , n. r, ,
1 » i v* U ' a
Y TMCX *
The tracks assigned on tape side B
The recording will start after the system completes the “One-touch
editing operation" on page 33.
Press DOLBY NR so that the
DOLBY NR IN indicator lights.
4
REVERSE WOE
Press REVERSE MODE to se¬
lect “ ctD ” for automatic two-
sided recording.
Press * OPEN/CLOSE on the
compact disc player to load a
disc, and then press it again.
Notes
•Use a tape of under 99 minutes.
•You cannot edit-record tracks numbering higher than 24.
Allotting tracks to the tape without wasting
tape space (J.FIT)
J.F1T
Sb
Press J.FIT.
Lights.
Tj.it i n-n i c
A i T , , <_' ■ U >
1 UN IK
W>
The recording will start after the system completes the “One-touch
editing operation” on page 33.
Notes
• Use a tape of under 99 minutes.
•You cannot edit-record tracks numbering higher than 24.

Technics SC-CH404 Specifications

General

Brand	Technics
Model	SC-CH404
Category	Stereo System
Language	English