Technics SH-GE70 User Manual

Equalization-preset indicators Memory-mode indicators
(
I 1 Technics
CZ3
s»,«,
I
Graphic Equalizer SH-GE70
.1111.
— _. 1 ^ I ^ 1 ™ j nm'Jt sw
1
I
i i i ; IP= — '
1
- B - m - - -1
-|-|-..-l-
:
o*», \ \ ™
I— — — •— — "^— — — — — — — —— — — — — — — — — — ——————— — — — —
1
i i
-
™-| , | , | ,
~ 1 EOon/oH 1 mwH 1 EOWM
f
• 1 >
T I,,,, **
^~,
e
SMemav Piesets
EZZD £==11
J
To retrieve equalization curves from the memory
This unit has been pre-programmed with six types of typical
equalization curves which are applicable to certain styles of music.
1
Press the "memo mode" button.
manual: Select this mode when you want to retrieve a
equalization curve that you have programmed
into memory.
fixed: Select this mode when you want to retrieve a
equalization curve that was originally program-
med into memory as a permanent ("fixed") curve.
(The memory-mode indicator will indicate the selection
made.)
Press one of the preset-memory buttons,
whichever corresponds to the curve to be
retrieved.
(The corresponding equalization-preset indicator will illu-
minate.)
•While in the "fixed" mode, if one of the equalizer level-control
buttons is pressed, the unit will automatically switch to the
"manual" mode.
Note:
Curves programmed into the memory will be retained for about two
weeks if the AC power supply cord is unplugged. If curves are
erased, they must be programmed again. Note, however, that
curves originally programmed beforehand into the unit's memory
as permanent curves (the "fixed" curves) will not be erased.
• "MOST RECENT" (recall) memory
The last position of the EQ level controls (whether in memory or
adjusted manually) will be automatically entered into the memory
when the power is switched OFF. When the power is switched ON,
these positions will be recalled.
-9-

Technics SH-GE70 Specifications

General

Total Harmonic Distortion	0.005%
Control Range	±12dB
Type	Graphic Equalizer
Input Sensitivity	150mV
Frequency Bands Specific	63Hz, 160Hz, 400Hz, 1kHz, 2.5kHz, 6.3kHz