Technics SL-EH60

Drive rack
Tray base
Marking “p>”
Drive gear
Pulley gear
Tray base
Projection
Stopper
| SL-EH60
Insert the drive rack until the driver rack
interferes with the drive gear.
Position @
ZED || Rotate the pulley gear clockwise gently by hand
(5 or 6 times).
@ When the gear begins to rotate, rotate the
pulley gear with finger pressure (position ® )
because the drive rack gear will fall free.
vy
Gx | Allow the tray base be open manually.
* Draw the inserted tray base forward.
\y
Locate the projection at the marking “BP” as
shown left.
D In case that the stated above is not operated
draw the tray base again.
(Refer to item (1) on page 9)
(Retry the item marked with @)
Tray base
-~11-