19
English
2 Press [NWP].
3 Press [N INPUT O] below [NWP] repeatedly
to select “USB”.
4 Press [3, 4] to select an item and then
press [OK].
≥If there are any other items, repeat this step.
Operations on the remote control
∫ Random repeat playback
Press [RND].
Each time you press the button:
∫ Repeat playback
Press [`].
Each time you press the button:
≥ You can use repeat playback in combination with programme
playback.
This function allows you to programme up to 24 tracks.
Preparation
≥It is not possible to programme tracks by moving folders.
Move all the tracks you want to programme to a single
folder in advance.
1 Select the folder containing the music file to
which you want to set programme playback.
2 Press [PGM] in the stop mode.
≥“Program Mode” screen will be displayed.
3 Press [OK] to display the programming
screen.
4 Press [3, 4] to select the desired track.
5 Press [OK].
≥Do steps 3 through 4 again to programme other tracks.
6 Press [1/;] to start playback.
≥To return to the “Program Mode” screen, press [∫].
Operations on the remote control
≥ Programmed content is maintained as long as the input source is
set to “USB”.
≥ The programme memory will be cleared:
– When the USB device is disconnected.
– When the unit is turned to standby or off mode.
≥ You can use programme playback in combination with repeat
playback.
Stop Press [∫].
Pause
Press [1/;].
≥ Press again to restart play.
Skip Press [:] or [9] to skip track.
Search
During play or pause, press and hold
[6] or [5].
≥
On the unit: press and hold [
:
] or [
9
].
≥ This operation may not be available for
some formats.
On
All tracks in a folder are repeated
randomly.
≥ “RND `” is displayed.
≥ During random playback, you cannot skip to
the previous track.
Off Turns off random repeat mode.
1-Track
Only plays the selected track.
≥ “1 `” is displayed.
All
All tracks in a folder are repeated.
≥ “`” is displayed.
Off Turns off repeat mode.
Programme playback
Stop
Press [∫].
≥ Programmed content is maintained.
Check the
programmed
order
Press [2, 1] in the stop mode.
≥ To return to the “Program Mode” screen,
press [OK].
Add tracks Do steps 3 through 4 in the stop mode.
Clear the last
track
Press [CLEAR] in the stop mode.
≥ It is not possible to select and clear the
desired programmed track.
Cancel
programme
mode
1 Press [PGM] in the stop mode.
≥ “Clear Program List?” is shown.
2 Press [3, 4] to select “Yes” and
then press [OK].
≥ The programme memory will be
cleared.
(19)
ST-C700DE-TQBM0007.book 19 ページ ２０１６年１０月２６日 水曜日 午後１時１７分
To Next Page
Loading...
Need help?
General