Technics ST-C700D

24
Listening to DAB/DAB+
You can preset up to 20 channels.
Preparation
≥Make sure that the DAB antenna is connected. (> 10)
≥Press [NWP] and then [N INPUT O] below [NWP]
repeatedly to select “DAB/DAB+”.
– If you select “DAB/DAB+” for the first time, the system will start
the “DAB auto scan” procedure.
1 Press [NWP].
2 Press [MENU].
3 Press [3, 4] repeatedly to select “Auto
Scan” and then press [OK].
4 Press [3, 4] to select “Yes” and then press
[OK].
≥“Auto Scan” is displayed.
To find the best antenna position, use manual tuning to
search selected DAB frequency block.
1 Press [NWP].
2 Press [MENU].
3 Press [3, 4] repeatedly to select “Manual
Scan” and then press [OK].
4 Press [3, 4] to select a frequency block to
scan and then press [OK].
1 Press [NWP].
2 Press [6] or [5] to tune in to the station.
3 Press [PGM].
4 Press the numeric buttons to select a preset
number.
≥Do steps 1 through 3 again to preset more stations.

≥ A station previously stored is overwritten when another station is
stored in the same preset number.
≥ You cannot preset a station when the station is not broadcasting or
when you have selected a secondary service.
≥ Previous station memory is cleared during auto scan.
1 Press [NWP].
2 Press the numeric buttons, [:] or [9] to
select the preset station.
You can view information about the DAB broadcast,
programme type, ensemble label and frequency.
1 Press [NWP].
2 Press [INFO] to view available information.
Some DAB/DAB+ stations provide a secondary service as
well as the primary service. If the station you are listening to
is providing secondary service, “ ” will be displayed.
1 Press [NWP].
2 Press [MENU].
3 Press [3, 4] repeatedly to select
“Secondary” and then press [OK].
4 Press [3, 4] to select the secondary
service and press [OK].

≥ The setting will go back to primary service when changes are
made (e.g. the station is changed).
When adjusting the antenna, you can check the reception quality.
1 Press [NWP].
2 Press [MENU].
3 Press [3, 4] repeatedly to select “Signal
Quality” and then press [OK].
4 Press [3, 4] to select frequency.
DAB auto scan
DAB manual tuning
Memory presetting
Selecting a preset station
Viewing available information
DAB Secondary
DAB signal quality
Frequency block
Frequency
Reception quality
0 (poor) to 8 (excellent)
e.g.,
(24)
ST-C700DE-TQBM0007.book 24 ページ ２０１６年１０月２６日 水曜日 午後１時１７分