27
English
Occasionally, Panasonic may release updated firmware for
this unit that may add new features or improve the ways
existing features operate. These updates are available free
of charge.
≥For the update information (new or improve features), refer
to the following website.
www.technics.com/support/firmware/
≥ During the update process, no other operations can be performed.
≥ If there are no updates, “Firmware is Up To Date” is displayed. (No
need to update it.)
≥ Updating the firmware may reset the settings.
∫ Update via internet
Preparation
≥Connect this unit to the network. (> 12)
– Make sure that the network is connected to the Internet.
1 Press [NWP].
2 Press [HOME].
3 Press [3, 4] repeatedly to select “SETUP”
and then press [OK].
4 Press [3, 4] repeatedly to select “F/W
Update” and then press [OK].
5 Press [3, 4] to select “Internet” and then
press [OK].
6 Press [3, 4] to select “Yes” and then press
[OK].
≥The progress is displayed as “Updating %” while
updating. ( stands for a number.)
≥When the update has finished successfully, “Success”
is displayed.
7 After “Success” is displayed, disconnect the
AC mains lead and then reconnect it after 3
minutes.
≥ Downloading may take longer or may not work properly depending
on the connection environment.
∫ Update via USB flash memory
Preparation
≥Download the latest firmware on the USB flash memory.
For details, refer to the following website.
www.technics.com/support/firmware/
≥FAT16 and FAT32 file systems are supported.
1 Connect the USB flash memory with new
firmware.
2 Press [NWP].
3 Press [HOME].
4 Press [3, 4] repeatedly to select “SETUP”
and then press [OK].
5 Press [3, 4] repeatedly to select “F/W
Update” and then press [OK].
6 Press [3, 4] to select “USB” and then press
[OK].
7 Press [3, 4] to select “Yes” and then press
[OK].
≥The progress is displayed as “Updating %” while
updating. ( stands for a number.)
≥When the update has finished successfully, “Success”
is displayed.
8 After “Success” is displayed, disconnect the
AC mains lead and then reconnect it after 3
minutes.
≥ Downloading may take longer depending on the USB flash
memory.
∫ Checking the firmware version and the
model number
1 Press [NWP].
2 Press [HOME].
3 Press [3, 4] repeatedly to select “SETUP” and then
press [OK].
4 Press [3, 4] repeatedly to select “F/W Version” and
then press [OK].
≥ The firmware version and the model number are displayed.
≥ Press [OK] to exit.
Firmware updates
Downloading takes approx. 10 minutes.
Do not disconnect the AC mains lead or lower the
power switch lever to the [OFF] position while one of
the following messages is displayed.
“Linking” or “Updating %”
(27)
ST-C700DE-TQBM0007.book 27 ページ ２０１６年１０月２６日 水曜日 午後１時１７分
To Next Page
Loading...
Need help?
General