Technics SU-V460

m LOCATION OF CONTROLS
eFront Panel
=,
root te
[6]
[9] (8) [7]
[1] Power switch (power) |7| Mode selector (mode)
[2] Operation indicators [8] Loudness switch (loudness)
(amplifier operation monitor) 9|Tone control switch (tone control)
'3|Power amplifier direct switch 10] Balance control (balance)
(power amp direct)
11] Tone controls (bass/treble)
[4] Volume control/indicator (volume) CS
[5]
Input
selector
(input
selector)
12|
Speaker
selectors
(speakers)
[6] Recording output selector (rec selector) 13} Headphones jack (phones)
e Rear Panel
-— PLAYBACK REC OUT—>
TAPE | TAPE2/ DAT
REC OUT) 7PLAYBACK-
ree
ae
POWER
AMP
AC
OUTLET
TUNER}
AUX
DIRECT
fans
wee
only
AC
INLET
al
>) A} ma In () —
SPEAKER
O Gir scone we)!
VOLTAGE SELECTOR
for (GC) area only
*Phono input capacitance is about 270 pF for EG area
(about 100 pF for other areas).
= DISASSEMBLY INSTRUCTIONS
1. Remove the 2 screws (@, @).
2. Remove the shield plate (R).
3. Remove the 3 screws (@~@).
Procedure _—CNIO2
1523
Remote Switch
Controller
Front Panel
4. Remove the 2 connectors (CN101, CN102).
; ae 5. Remove the remote switch controller.
f menos ineipower-sallich Duan by puSning tien 6. Remove the front panel in the direction of the arrow.
behind the front panel.
2. Remove the 2 screws (@, @). @ Removal of the remote switch controller
3. Release the 1 claw. aRciwve the 4claws
Procedure Remote Switch
| Controller ~_
1-24
Replacing of the remote switch controller
1. Fully rotate the Recording Selector Control
counterclockwise.
2. Push the Switch Slide in the direction of the arrow.
Lever
Switch Slide
%%™
Removalofthe LEDP.c.B. ©
1. Remove the 1 screw (@).
2. Release the 2 claws.
Removal of the headphones P.C.B.
1. Remove the 2 screws (@, ©).
2. Release the 1 claw.
Rec Selector Knob