Technics SX-KN1600 - Symptoms Which Appear to be Signs of Trouble

SYMPTOMS WHICH APPEAR TO BE SIGNS OF TROUBLE
The following changes in performance may occur in this instrument but do not indicate trouble.
[—_[___Fhenamenon——SS—~—~—“‘iSSC“‘CEC‘#Womedy=—S—=—~—~S~S
Sounds and effects
AUTO PLAY
The buttons, keys, etc. malfunction. ¢ Turn off the POWER button once, then turn it on again.
If this procedure is not successful, turn off the POWER
button once. Then, while pressing the three lower left
buttons in the RHYTHM GROUP section (MARCH &
WALTZ, LATIN and WORLD) at the same time, turn
the POWER button on again. (Note that, in this case,
all programmable settings, functions and memories
return to their factory-preset status.)
No sound is produced when the keys are pressed. | e The MAIN VOLUME is at the minimum setting. Adjust
the volume with the MAIN VOLUME conirol.
eThe volumes for the selected parts are set to the
minimum levels. Use the balance buttons to set the
volumes of the relevant parts to appropriate levels.
e The part is muted.
eThe LOCAL CONTROL for a part performed on the
keyboard is set to OFF. Set the LOCAL CONTROL to
ON.
Only percussive instrument sounds are produced|eIn the SOUND GROUP section, the DRUM KITS
when the keyboard is played. button is on.
The volume is very low when the keyboard is}eThe volume setting in the SEQUENCER conients is
very low. Follow the INITIAL procedure to reset the
settings.
Some sounds cannot be selected. e When the GENERAL MIDI status is set to ON, The
sounds which can be selected and operation which
can be executed are limited. Turn the GENERAL MIDI
status OFF to return the instrument to its normal
operation.
The sound you hear is different from the sound you|*This sometimes occurs when you play back
SEQUENCER or COMPOSER data which was created
on a different model, or when MIDI data is received
from a connected instrument. Select the desired
sounds again.
The rhythm does not start. e The DRUMS volume is set to the minimum level. Use
the balance buttons to set the DRUMS volume to an
appropriate level.
eA SEQUENCER PLAY button is on. When you are
not playing back the SEQUENCER performance, turn
off the SEQUENCER PLAY button.
eCLOCK is set to MIDI. Set CLOCK to INTERNAL.
e The rhythm does not work when the GENERAL MIDI
mode is set to ON. Turn the GENERAL MIDI status
OFF to return the instrument to its normal operation.
No sound is produced for the automatic accom-| «An ACCOMP pari does not sound if its corresponding
paniment, or only the sounds of some parts are| volume is set to the minimum level. Use ithe respective
produced. : balance buttons to set the ACCOMP 1, 2 and 3
volumes to appropriate levels.
( )
()
(>
()