DVD Operation
2.Place the disc (with labelside facing user)to the door and the unit willdraw in the disc
automatically.
1. Power on and switch signal source to DVD mode and the unit begins to work.
3. Press [PLAY] button to begin playing disc.
4. Press [STOP] button to stop playing.
6. When finishing playing, switch signal source to other working state and press [ ]
button to make the unit enter standby state. Please pull out the
power plug from power
socket when not using the unit for a long time.
PLAYBACK
The unit begins to read disc information.
CDVCDSVCDDVD
MPEG4
5. Press [ ] button to take out disc.
When the unit is playing a disc, press[ ] button the first time and the unit enters pause state, while
press [ ] button again and the unit resumes playback.
When the unit is playing a disc, press [ ] button the first time and the unit enters pre-stop state,
while press [ ] button again and the unit enters stop state.
At the pre-stop state, if you press [ ] button, the unit will continue to play from the stopped point.
At the stop state, if you press [ ] button, the unit will play from the beginning point of the disc.
Press [ ] button when playing MPEG4 discs and the unit enters stop state directly.
[ ] button is effective only when selecting DVD signal source. In other signal source ,such as TV,
AV, etc, this button is invalid.
2. Press [VOL+/VOL-] buttons on the remote control of this unit.
Press [VOL+] button to increase volume; press [VOL-] button to decrease volume; the
maximum volume is 100.
CDVCDSVCDDVD
1. Press [VOL+/VOL-] buttons to adjust volume.
MPEG4
VOLUME CONTROL
32" HD Ready LCD/DVD TV User Guide 33
To Next Page
Loading...
Need help?
General
