Use and Care
Positioning the oven trays & shelves
The Grill Tray or Oven Shelf can be located in any of the five height
positions in the oven if your oven does not have Telescopic Shelf
Supports. Oven Shelves cannot be fitted to the Telescopic
Support. Only fit the Grill Tray to the Telescopic Support.
Refer to the ‘Cooking Guide Table’ for the recommended shelf
position. When fitting the trays or shelves, ensure they are fitted
between the two wires that are closest together as shown below.
Oven Shelves have a stop so that they are not fully withdrawn by
accident. To fully remove the Oven Shelves, lift the front of the
shelf slightly and withdraw fully from the oven. Note that the Grill
Tray does not have a stop position and can be fully withdrawn
without interruption, so be careful not to accidentally fully withdraw
the tray.
To remove the Oven Shelf
Support, push down on the
wire below the locking pin,
pull away from the oven wall
until you can release the top
of the support from the
holes in the oven wall.
Replace in reverse
procedure.
Fit Trays and
Shelves
between bars
as shown right
Oven Shelf fitted to chrome
wire Shelf Support
Grill Tray fitted to Telescopic
Shelf Support
9
To Next Page
Loading...
