Cautions
• The hob must be installed by a suitably qualified person. Please never conduct the
operation by yourself.
• The ho
b shall not be mounted to cooling equipment, dishwashers and rotary dryers.
• The hob shall be installed in a way that ensures correct ventilation and clearances.
• Any
surrounding surfaces will meet requirements in regards to temperature
resistance.
• A s
team cleaner is not to be used.
Electrical Connection
Connecting the hob to the mains power supply
If connecting the cable directly to the mains, install a suitable isolating switch with
a
minimum contact opening of 3mm between the appliance and the mains. The isolating
switch should be sized according to the load on the appliance rating label and should
comply with current regulations (the earth wire should not be interrupted by the circuit
breaker)
Connection to the electricity supply must be made by an authorized person in
accordance with the wiring rules AS/NZS3000. Ensure the supply cable cannot contact
any hot surfaces.
Immediately after installation, carry
out a thorough inspection and test of the appliance.
If the appliance fails to operate correctly, after checking that you have followed the
user instructions correctly, disconnect the appliance and contact the Technika Service
department. Never attempt to repair the appliance.
24
TGGCE64-5
TGGCE74
To Next Page
Loading...
Need help?
General
