Semi
automatic operation and end of cooking time
Press
the end of cooking time key (3) and set the required time by
means
of the +/-
(4+5)
keys. The symbol A and the symbol of the
saucepan
will
light
up. The relay
output
will
be activated.
If
clock=end of the cooking time, the relay and
saucepan
symbol
will
switch off.
The buzzer
will
sound and the symbol A
will
blink.
Completely automatic operation
Press
the duration key (2) and set the required time by
means
od the +/- keys (4+5).
The symbol A
will
appear.
The relay
will
come on the
saucepan
symbol
will
appear.
Select he End of cooking time function (3)- the minimum setting time
will
appear.
Set the required time by
means
of the +/- keys (4+5).
The relay and the
saucepan
symbol. The
saucepan
symbol
will
re-appear
when the
clock
time=the calculated switch-on time.
After
setting the automatic program the
symbol
A
will
blink.
The buzzer
will
sound and the
saucepan
symbol and relay
will
switch
off.
Minute control
Press
the Minute control key (1) and set the required time by
means
of the +/- keys
(4+5).
While
the set time runs, the
bell
symbol
will
appear.
When
the set time
elapses,
the buzzer
will
sound.
Buzzer
The buzzer remains active for 7 minutes after the minute control cycle or the
cooking
program has finished.
Press
any function key to stop the buzzer.
Program
start-up and check
A
set program is run when the required time has
also
been
set. The remaining timers
can be checked at any time by selecting the relevant function.
Setting error
The setting is not correct
if
the clock time is between the begininning of the cooking
time
and the end of the cooking time.
The error is indicated via sounding of a buzzer and
blinking
of the Auto symbol. An
incorrect setting can be correced by re-setting either the beginning or end of cooking
time.
Cancelling
a program
A
program can be cancelled by selecting the manual function. A set program is
automatically
cancelled when it
reaches
the end of its cycle.
6
Oven
door (Fig 3)
Clean the oven door using non-abrasive products.
The
glass
panel can be easily removed and cleaned by unscrewing the two
screws
at
the side shown in figure 3
Fig.
3
Removing the
oven
door
The oven door can be removed to facilitate cleaning of the oven.
-Hinges with mobile levers (figure 4)
With
the door open,
raise
the levers B. |
Lift
the door upwards and
pull
out, gripping
the
sides
near
the hinges.
To
refit
the door, slide the hinges into
their
grooves and then lower leverB.
Fig.
4
Replacing
the bulb (Fig 5)
CAUTION:
Switch
off
the oven.
If
you
need
to replace a bulb B, remove the protective
cover A by turning it anti-clockwise.
After
replacing the bulb,
refit
the protective
cover A
(fig
5).
Globe: 25 wattSES14
To Next Page
Loading...
