PG 19
INSTALLING COOKER POWER CONNECTIONS
Electrical Connection
The appliance is supplied fitted with a power cord and 3 pin plug. Install the cooker so that the plug is easily
accessible. Plug the 3-pin plug into a properly earthed, 10A general purpose power outlet preferably on a
separate dedicated circuit.
If a permanent connection is used, the appliance's power supply line must be fitted with an omni polar breaking
device with contact gap of at least 3 mm, located in an easily accessible position close to the appliance itself.
If a socket and plug connection is used, check that they are of the same type. Do not use reducers,
adapters or junctions since they may cause overheating or burns.
Operation at 220-240 V～: use a type H05RR-F three-wire cable
(Cable of 3 x 1.5 mm²).
WARNING: Installation MUST ONLY be carried out by a qualified approved installer, ie. an Electrician.
NOTE: REFER to TECHNICAL tables at the rear of this manual for correct rating for your corresponding model
purchased.
NOTE: All Upright cookers must comply to local regulations to Australian Standard AS/NZS 3000:2007
guidelines. Qualified Electrician will have a copy of these guides that MUST be adhered to.
To Next Page
Loading...
Need help?
General
