PG 8
Preparing your appliance for the first time
• Please wipe out the oven interior prior to operation with warm
soapy water and polish dry with a soft clean cloth.
• New appliances can have an odour during first operation from
components manufactured with the aid of oils It is recommended
to ‘run in’ your oven before you cook for the first time. Run the
empty oven at 180°C for approximately 1 to 2 hours. Ensure that
the room is well ventilated.
• Please install oven furniture as outlined in the “Fitting Oven
Accessories and Cleaning” section.
• If your appliance is fitted with solid hotplates, turn heat setting to high for 3 minutes to fully harden the coating.
When cooled, apply a thin coating of cooking oil to seal the surface.
• The grill element may have oils left on the grill during manufacture. Before you cook on the grill for the first
time, turn on for 15 minutes with 10mm of water in the bottom of the grill dish.
Fitting oven shelves
• Ensure shelf orientation is correct (refer picture).
• The shelf has a safety bar fitted to reduce the risk of dishes sliding o the shelf, this is the rear of the shelf
• Slide into oven at an angle until raised back of shelf is past the stop on side runners.
• Lower front of shelf and push in until stop is reached.
NOTE: The top ledge is not a shelf position
Oven shelf positions
• The main oven has 5 shelf positions to choose from. Position 1 is the position at the bottom of the oven and
position 5 is located at the highest point of the oven
• The 5 position side rack system can house both the standard oven shelves and baking tray.
FIRST TIME USE OF THE APPLIANCE
To Next Page
Loading...
Need help?
General
