PG 22
Safety warnings about installation
• The cooker MUST BE installed and serviced only by an authorised person.
• A certificate of compliance must be supplied by installer and is to be kept by the customer.
• The packing materials must be removed before you install the cooker.
• You must follow the installation instructions in this booklet and AS/NZS 5601.
• The surrounding kitchen cabinets MUST BE able to withstand 95°C. We will not accept responsibility for
damage caused by installation in to kitchen cabinets which cannot withstand 95°C.
• The appliance must not be installed in a corner. It must be installed at least 100mm from the side wall.
• The flexible pipe for gas models must have sucient loops so the cooker can be moved for service.
• The vents; openings and air spaces MUST NOT be blocked.
• The anti-tilt floor bracket must be installed to avoid accidental tipping.
• The stability bolt must be installed to avoid accidental moving.
• You must not pull the cooker by the door handles.
• Power socket, if provided for gas models, and electricity isolation switch for electric models and gas models
without a 20A plug, is to be installed in an accessible position near the cooker (but not behind cooker).
• If the supply cord or cable is damaged, it must be replaced by an approved service agent or a similarly
qualified person in order to avoid a hazard.
The installation of splash back
• To fit splash back, align the 2 tabs of the splash back with the corresponding holes in the hob and push
downwards.
• Fit screws.
To Next Page
Loading...
Need help?
General
