USING THE CONTROLS
How to set the oven for roasting when using the probe
· Insert the probe into the meat.
· Plug the probe into the outlet in the oven. Make sure it is pushed
all the way in. If the Probe is inserted correctly, will shows
on the display.
· Close the oven door.
· Turn the Divider Select Knob to single mode, then turn the Time
/ Temp / Function Control Knob to select the function you need.
· Push the Temperature Button, the oven temperature will shows
on the display,you can using the Time / Temp / Function Control
Knob set the desired oven temperature, in 5°C increments, from
40°C to 250°C.
· Push the Temperature Button again, the Probe temperature will
shows on the display, you can using the Time / Temp / Function
Control Knob set the Probe temperature ,in 5°C increments,
from 40°C to 95°C.
· When the internal temperature of the meat reaches the number
you have set, the probe and the oven turn off ,End will show in
the display and the oven control will beep.
Setting the divider mode
For upper, twin and lower modes, insert the divider at the “OFF”
position of Divider Select Knob. For single mode, remove the
divider at the “OFF” position. And then turn the Divider Select Knob
to select the mode you want. For further details, see the table
below.
1 Turn the Divider Select Knob to select the desired
partition.
2 Press the Function Button and hold for about 3 seconds.
3 Turn the Time / Temp/ Function Control Knob to select the
desired oven function. If 3 seconds have elapsed and there are
no further adjustments, the oven will begin automatically in the
selected mode and function.
Use and Care
18
To Next Page
Loading...
