TechniSat AUDIOMASTER MR1 User Manual

30
6.6 Using the audio input
It is possible to play sound from external devices using the analogue audio output.
> Connect the external device to the AUX IN connection (11), (3.5mm jack) on the device rear.
> In Source selection tap the AUX IN item.
To set the volume optimally, use the volume control both on the device and on the connected external
device.
Please note that if the volume on the connected device is very low, while the speakervolume setting is
higher, annoying noises/background noise will be amplified and, therefore, will clearly be heard. It is
recommended that you set the speaker volume, e.g. on an Internet radio station, switch to the audio input
and then to adjust the volume of the connected device in such a way that the overall volume of the audio
input corresponds approximately to the volume of the Internet radio station. In this way, you can also
avoid considerable differences in volume when switching between the speaker functions.
6.7 Other buons on the device
The following buttons can be found on the top of the device:
> VOL - (10), volume control, down (TECHNISOUND MR2 only)
> VOL +(9), volume control, up (TECHNISOUND MR2 only)

TechniSat AUDIOMASTER MR1 Specifications

General

Product color	Aluminium, Black
Housing material	Aluminum
Recommended usage	-
Multi-Room Streaming (MRS) support	Yes
Speaker placement	Tabletop/bookshelf, Wall-mountable
Audio output channels	1.0 channels
RMS rated power	30 W
Connectivity technology	Wired & Wireless
Power consumption (standby)	1.5 W
Power consumption (typical)	36 W
Type	Home audio micro system

Weight and Dimensions

Width	110 mm
Height	220 mm
Weight	1360 g
Package depth	200 mm
Package width	265 mm
Package height	165 mm
Package weight	1920 g