13
> Press the OK button to open the window containing the programme providers
available for selection.
> Use the up/down arrow keys to select the programme provider you want and
follow the instructions on the screen.
Antenna signals
In this section in the installation wizard, select how many antenna cables are connected to
the receiver.
> Use the right/left arrow keys to select whether you have connected 1 or 2
antenna signals.
> Confirm with the OK key to accept the selection.
Antenna configuration
In this step of the installation you can adapt your digital receiver setup to the configuration
of your antenna.
> If you want to accept the default antenna setting, press the OK button.
> If the configuration of your reception equipment does not conform to the default
setting, press the Options key.
> Then create the antenna settings according to your reception equipment and press
the Back key to go back to the antenna configuration overview.
> Then confirm with the OK button to accept the settings.
Network configuration
In this step the device will automatically check for a network configuration.
> If you do not want to run the network configuration check, press the Info button.
To Next Page
Loading...
Need help?
General
