TechniSat DIGITRADIO 20 User Manual

16
3. To manually scan the FM frequency, while FM frequency shows up, turn SCROLL/SELECT knob clockwise
or anti-clockwise to change the frequency by 0.05MHz per step.
4. To automatically scan, while FM frequency shows up, turn SCROLL/SELECT knob clockwise or
anticlockwise and then SCROLL/SELECT knob, your radio will skip forwards or backwards until it reached
the next available station.
5.1 Scan seing
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss) from weak
stations.
1. To change the scan seings to stop only at stations with good signal strength, press MENU buon, and
then turn SCROLL/SELECT knob to select ‚Scan seing‘, press SCROLL/SELECT knob to confirm.
2. Turn SCROLL/SELECT knob to select ‚Strong stations only‘, and then press SCROLL/SELECT knob to
confirm.
5.2 Audio Seings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor signal-to-noise
ratio (hiss).
1. To play weak stations in mono, press MENU buon, and then turn SCROLL/SELECT knob to select ‘Audio
seing’, press SCROLL/SELECT knob to confirm.
2. Turn SCROLL/SELECT knob to select ‚Forced mono‘, and then press SCROLL/SELECT knob to confirm.
5.3 Storing Preset Stations
Your radio can store up to 10 of your favourite FM stations. This will enable you to access your favourite stations
quickly and easily.
1. While your favorite station is playing, press and hold 4+ buon until display show ‘Preset Store <#:
(Empty)>’.
2. Turn SCROLL/SELECT knob to select among preset numbers 1-10, and then press SCROLL/SELECT knob to
confirm. The display will show ‘Preset # stored’.

TechniSat DIGITRADIO 20 Specifications

General

Brand	TechniSat
Model	DIGITRADIO 20
Category	Radio
Language	English