TechniSat Digitradio 361 CD IR

52
14 Other functions
14.1 Sleep function
> You can set the sleep function using MENU > Main menu > Sleep.
> Using the r/s PRESET buons on the remote control (7, 9), or by rotating SELECT/VOLUME on the
device (5), you can set the period in steps of 15, 30, 45 and 60 minutes aer which the device switches to
standby, or you can switch the Sleep function o again by selecting Sleep o.
> Confirm your selection with the ENTER buon on the remote control (27) or by pressing the SELECT/
VOLUME knob on the device (5).
Alternatively:
> Press the SLEEP buon on the remote control (16) as oen as required until the desired value is shown on
the display (4).
When the sleep function is active, a clock symbol appears on the status bar on the display with the
remaining time until the DIGITRADIO switches to standby.
14.2 Alarm
> Using MENU > Main menu> Alarm you can retrieve the alarm seings.
Alternatively:
> Press the TIMER buon on the remote control (20), to access the alarm seings directly.
14.2.1 Seing the alarm time
The alarm function cannot be used until the correct time has been set. Depending on the set-up, this
either occurs automatically or has to be set manually.