11
b. Turn SELECT/TUNE knob to cycle through the alphanumeric character list, press
SELECT/TUNE knob to select an appointed character.
# Note: WEP/WPA pass codes are case-sensitive.
c. If a wrong operation is being conducted, select to delete designated
character.
# Note: = Backspace; means return to previous track; radio
will automatically save the WEP/WPA you’ve input, so no bother to re-enter these
codes.
d. After selecting the final character of your password, turn SELECT/TUNE knob to
, and then press SELECT/TUNE knob to confirm. The radio is connected to
wireless network.
# Note: If a password (WEP/WPA) isn’t required by your network, radio will connect to the network
automatically.
4. Setup wizard completed, press SELECT/TUNE knob again to exit.
To Next Page
Loading...
