27
Bluetooth Mode
Pair the unit with a Bluetooth device to listen to music:
1. Press the MODE button to select Bluetooth mode.
2. The display will flash in repeatedly.
3. Activate your Bluetooth device and select the search mode.
4. ‘DigitRadio 510’ will appear on your Bluetooth device.
5. Select ‘DigitRadio 510’ and enter “0000” for the password if necessary.
6. The icon will remains steadily on the display when connection is successful.
7. While a track is playing, you can:
a. Press button once to resume to the beginning of track, then press button once
again to skip to previous track; press and hold button to fast reverse current playing
track.
b. Press button to pause or play current playing track.
c. Press button to skip to next track; press and hold button to fast forward current
playing track.
8. To disconnect the Bluetooth connection, press MENU button, turn SELECT/TUNE knob to
select ‘BT disconnect’, and then press SELECT/TUNE knob to confirm. The display will
show ‘Device disconnect?’, turn SELECT/TUNE knob to select ‘YES’, and then press
SELECT/TUNE knob to confirm.
# Note: the unit will automatically switch to standby mode after 30 minutes if the source device
is disconnect, switch off or the volume is too close to mute.
NFC (Near Field Communication)
NFC enable you pair and connect with Bluetooth devices in a easy way.
1. Press MODE button repeatedly to select Bluetooth mode.
2. Make sure that your NFC is turned “On” on your mobile device.
3. Hold your mobile device about 2cm close to NFC sensor on front panel for receiving an
auto-connection between your mobile device and radio.
4. Your device then will turn-on Bluetooth automatically and will pair your device with radio. No
additional settings are necessary.
To Next Page
Loading...
Need help?
General