TechniSat DIGITRADIO 650

69
DE
EN
FR
NL
> Select a sorting type with  or  and confirm your selection with OK.
You can now choose between: Alphanumeric and provider.
14 FM radio
14.1 Switching on FM radio mode
> Press the MODE buon as oen as required until [FM-Radio] appears on the
display. Or press the FM (13) buon on the remote control.
Alternatively:
> Press the MENU buon and then select [Main Menu > FM].
When you switch on the radio for the first time, the frequency is set to 87.5 MHz.
If you have already set or saved a station, the radio plays the last station set.
In the case of RDS stations, the station name is displayed.
Adjust the antenna to improve reception.
14.2 FM reception with RDS information
RDS is a procedure for broadcasting additional information via FM stations.
Broadcasters with RDS might, for example, broadcast their station name or the
programme type. This appears on the display.
> The device can show the following RDS information:
RT (radio text),
PS (station name),
PTY (programme
type).
14.3 Seing the broadcasting frequency manually
> Press the  or  key repeatedly to set the desired broadcasting frequency.
The display shows the frequency in increments of 0.05 MHz.
14.4 Automatic scan
> Press SCAN to start the automatic scan. The station frequency runs upwards
in the display.
or
> Hold down the  or  buon for approx. 2 seconds to search automatically
for the next station with a strong enough signal.