TechniSat MULTYRADIO 600 CD IR - Page 79

79
DE
EN
NL
19.3.2 WPS connection
> Select [Internet seings > PBC WiFi set up] if your router has the WPS
function. This establishes a direct connection to the router without having to
enter the - WiFi password.
How you activate WPS on your router can be taken from its instruction
manual.
> Start WPS on your router by pressing the relevant buon. Note the
Instructions on the MULTYRADIO 600 CD IR display.
19.3.3 More information about the network connection
To find out more about the current connection select [Show seings].
Select [Manual seings], if you know your network parameters and you
would like to configure them manually. Take note of the instructions on the
display.
The menu item [Net Remote PIN] can be used to configure the PIN for the
control with the TechniSat CONNECT app. The standard PIN is: 1234. The
TechniSat CONNECT app can be loaded free from the usual app stores.
Select [Delete network profile], to delete WiFi connections no longer
required.
Select [Reset seings] to clear all current Internet seings.
Select [Allow WiFi connection in standby mode] if the WiFi connection
should be retained in standby mode as well. This seing increases power
consumption but enables app control via the TechniSat CONNECT app
(switching on from Standby mode).
19.4 Time seings
> Press the MENU buon and then select [System Seings] > [Time and
Date].
> Select [Time/Date Seing] to set the time and date manually.
Use the OK buon to select a value. Change it using the  or  buons.
> Confirm by pressing OK.
> Select [Time Update] to determine whether the time update should be
automatic via DAB+, FM or Internet or whether you would like to enter it
manually.
> To do this, select [DAB+ update], [FM update], [NETupdate] or [No
update].
> Under the [Set format] option you can activate 12 or 24 hour format.
Confirm your selection with the OK buon.