TechniSat Technipolar 1

37
DE
EN
FR
IT
NL
PL
5 Installation instructions
5.1 Exhaust air discharge
In cooling or heating mode, the unit must be installed near a window or opening so
that the warm or cold exhaust air can be discharged outside.
Place the unit on a level floor and ensure that there is a minimum distance of 30 cm
around the unit and that it is close to an earthed socket.
1. Extend the hose to the desired length by unravelling it (Fig. 1)
2. Screw it onto the hose inlet (Fig. 2).
3. Screw the hose outlet onto the other end
of the hose (Fig. 3).
4. Mount the hose inlet onto the exhaust air
connection (7) (Fig. 4).
5. Aach the hose outlet to the window kit
(see “5.2 Fenster-Kit installieren“).
Aach
Lock