TechniSat Technipolar 1

46
> Point the remote control at the top of the air conditioner. Observe the
maximum distance of 7 metres.
8.3 Activating special functions with the remote control
8.3.1 Ventilation outlet
The upper ventilation outlet opens and closes slightly in a constant rhythm. If you
want to lock the ventilation outlet in one position, press the Air outlet buon on the
remote control.
Press the buon again to automatically adjust the panning.
8.3.2 Changing the temperature unit
Press the Temperature unit buon to switch the temperature unit shown on the
display between degrees Celsius and Fahrenheit.
8.3.3 Night mode
In night mode, the display and the LED on the top of the unit are dimmed.
> Select heat, cool or automatic mode.
> Press the Night mode buon on your remote control.
The displays are now dimmed and the fan runs at the lowest speed.
In cool mode, the temperature seing is gradually increased to 1 °C above
the original target temperature for each of the first 2 hours. The unit then
maintains the same temperature for 6 hours and then switches to standby
mode.
In heat mode, the temperature seing is gradually lowered to 1 °C below
the original target temperature for each of the first 3 hours. The unit then
maintains the same temperature for 5 hours and then switches to standby
mode.