43
DE
EN
FR
IT
NL
PL
6.6 Fan mode
If you use the unit in this mode, the exhaust hose does not need to be connected.
> Press the MODE buon (1) several times until Fan (10) lights up. Press the
FAN buon (5) several times to select the desired fan speed, where High,
Medium, or Low can be selected.
Automatic control is not available in this mode.
6.7 Automatic mode
In automatic mode, the unit independently decides which mode to use based on
the current room temperature:
- Up to 20°C room temperature = heat mode
- Between 20°C and 23°C = fan mode
- Above 23°C room temperature = cool mode
> Press the MODE buon (1) several times until all mode LEDs are switched o
and a rotating bar appears on the display.
> Press the FAN buon (5) several times to select the desired fan speed, where
High, Medium, or Low can be selected.
7 Timer mode
The timer can be used to automate switching the unit on or o.
Ecient use of the timer mode saves electricity, since the unit is only in operation at
the set times.
7.1 Programming the timer
Delayed switching on
> First select the mode and the desired seings (fan speed, temperature) while
the unit is in operation. Then switch o the unit.
> When the unit is switched o, press the TIMER buon (2). The timer LED (11)
and the number of hours flash on the display.
> Press the TIMER buon again several times within 5 seconds to set the hours
by which the unit should be switched on aer a delay.
The timer can be set in 1 hour intervals from 1 hour to 24 hours.
To Next Page
Loading...
Need help?
General