TechniSat Technipolar 1

50
The unit emits an
unpleasant odour while in
operation.
Air filter is blocked or
dirty.
Remove the air filter
and clean it as per the
instructions.
Aer a restart, it takes 3
minutes for the unit to
start working again.
The protective circuit of
the compressor prevents
an immediate start
aer the unit has been
switched o and on
again.
Wait 3 minutes. The unit
will then work as usual
again.
The following error
messages appear on the
display:
Lt
PF
Ft
The self-diagnosis
function has detected an
error.
Lt - temperature in the
room is too low. The de-
frost function starts.
PF - sensor error. Notify
our service department
Ft - condensed water
tank is full. Empty the
tank as described in these
instructions.