22
7.4 Changing a setting
You can create settings using the arrow selection method, the selection list, by entering numbers and
by using the virtual keyboard. The device specifies the method that can be used to change a highlighted
setting. This is evident on account of the following displayed symbols:
- Arrow selection method (Section 7.4.1)
Arrows are shown on the left or right edge of the highlight.
- Selection list (Section 7.4.2)
The symbol is shown on the right edge of the highlight.
- Entering numbers (Section 7.4.3)
- Virtual keyboard (Section 7.4.4)
The symbol is shown on the right edge of the highlight.
7.4.1 Arrow selection method
> If is shown on the left and on the right next to the set value, you can alter this using the left/right
arrow keys.
7.4.2 Selection list
If is shown on the right next to the set value, the value can be changed using the selection list.
> Press the OK button to open the selection list.
> Highlight the setting you want using the up/down arrow keys.
By pressing the up/down arrow keys, it is possible to move the highlight from line to line and to
move upwards and downwards page by page using the page up/down buttons.
> Confirm by pressing the OK button. The selection list closes again and the selected setting is shown in
the menu.
To Next Page
Loading...
