28
Filter
By setting one or more filters, you can limit the display to certain channels that fulfill the desired criteria.
> Highlight the Filter option and press the OK button.
> Now select the desired filter group and press the OK button once more.
> Now select the desired filter option from the list that appears and confirm the selection using the
OK button.
The channel list now only shows the channels that fit the desired criteria.
In order to filter the list further, follow the above steps again and set more filters this way.
To remove all filters
> Open the Options menu using the OPT button.
> Select the Filter option and press the OK button.
> Now select [Reset all filters] and press the OK button.
The full channels list is now displayed again.
8.3.4 Calling up blocked channels
If a channel is selected that is blocked by the parental control function, the device PIN message will be
displayed on the screen.
> Use the numeric keypad keys to enter the device PIN.
The selected channel can now be viewed.
or
> Switch to a channel that is not blocked.
If global parental control is enabled, the device PIN code will be requested again when the blocked
channel is switched on. To make things easier for you, you only need enter the PIN code once during
each operating phase.
When doing so, pay careful attention to the information and settings for global and user-dependent
parental control (TechniFamily) in the operating manual.
To Next Page
Loading...
