12
EN
3.6 Network port (RJ45)
Using the network port (9) you can connect the device to your existing network.
By doing so, you can, for example, use the Internet radio functionality or control the
device via the TechniSat CONNECT app.
To do so, also observe the Network seings section in your instruction manual.
3.7 Analogue Audio/Video connection
You can also operate the receiver on a TV or an external recording device with
analogue audio/video input. To do so, use the optionally available TechniSat specific
adapter set and connect it to the AV OUT (12).
4 Basic operation
Dear Customer,
The following section starts by covering basic operation as well as the recurrent steps
for operating the device. This should make it easier to read the quick start manual,
since it avoids repeated description of identical steps at each individual stage.
If a function or seing for the device needs to dier from the basic operation, the
dierence in operation is described in detail at the relevant point in the operating
manual.
The so-called "On Screen Display" (OSD) is used in your device. This simplifies the
operation of your device since the buons on the remote control can perform
dierent functions. This makes it possible to reduce the number of buons.
On this On Screen Display (OSD) the selected functions or seings can be
highlighted.
Furthermore, on the lower edge of the screen there is a line where individual buons
on the remote control are represented with their current functions. In this instruction
manual the terms shown in the OSD as well as the buons to be pressed are
distinguished from the rest of the text by the print format used.
Warning - indicates an important note which you absolutely should observe in
order to avoid problems with the device, loss of data or unwanted operation.
Tip - This identifies information relating to the described function, as well
as to another related function that may have to be taken into account, with
reference to the corresponding section in the manual.