TechniSat TECHNISTAR S6

21
EN
> You can use the up/down arrow buons within the options group to
highlight one of the options listed there.
By pressing the up/down arrow buons it is possible to move the highlight
from line to line and to move upwards and downwards page by page using
the page up/down buons.
> The highlighted option is selected by pressing the OK buon; you exit the
option selection area.
> If you do not want to select an option or wish to leave the option selection
area without making any changes, simply press the Option buon until it is
hidden.
5 Initial installation
Aer you have read the safety instructions and connected the device 3 as described
in Section4, you can switch it on.
On initial start-up of the device, theAutoInstallinstallation wizard starts
automatically. The installation wizard allows you to perform the most important
seings for your digital receiver in the simplest way possible.
Each step of the installation explains which seings can be performed.
> In the installation wizard start window, you can cancel the initial installation by
pressing the red function buon. The receiver then begins to run default pre-
programming.
In the subsequent installation steps you can press the OK buon to accept the
seing you have selected and move on to the next installation step.
By pressing the Back buon you can go back to the previous installation step.
This enables you to correct any incorrect entries at any time.
The initial installation shown here simply serves as an example.
The exact process for the initial installation will depend on the seings you select.
Therefore please follow all the instructions displayed on the screen.
Most of the seings in Autoinstall can also be changed at a later date via the
menu.