22
Synchro Excite
Unpacking
Depending on the country of destination, Synchro can either come partially assembled in a cardboard pack attached to a
pallet, or fully assembled, wrapped in a transparent plastic sheet and attached to a pallet.
The packed material can be lifted and carried with normal lifting equipment. The instructions are printed directly on the pack.
In order to ensure the safety of persons and property, you should think carefully about what lifting and transport equipment
to use, in relation to the equipment’s place of destination.
As stated in the instructions on the pack, to unpack equipment delivered in a cardboard pack, remove the staples that attach
the external packaging to the pallet, and then lift up the pack.
Check the pack visually to make sure it is in a good, complete state.
Remove the fasteners and place the contents of the pack on the ground.
The Assembly instructions are enclosed with this guide.
Warning
Observe the legally stated urban waste disposal procedures when disposing of the packaging material.
To Next Page
Loading...
