Technogym Excite Synchro - Switching On and Off

39
Synchro Excite
Switching on and o
To turn 700 and 500 versions of the equipment on, switch the switch to “I”
position.
To turn the 700 SP and 500 SP versions on, begin moving.
When switched on, a beep sounds and all the control panel LEDs light up.
After a quick system check (reset), the equipment is ready for use.
In this mode, the following functions are enabled:
- calculation of heart rate, if measured;
- reading of access codes for configuration menu (see the Configuration Menu section in the software part).