Technogym GROUP CYCLE - Saddle and Handlebar Adjustments

21
E
D
A
B
A
B
Group Cycle
Using the equipment
To make horizontal adjustments to the saddle and handlebar, turn the adjustment lever (A), move
the saddle to the required position and then return the lever to its original position.
The adjustment lever has a limited preset force to allow for easy opening.
To adjust the height of the saddle and handlebar, operate the lever (B) located underneath the
rear part of the saddle or the handlebar.
To raise the saddle or handlebar it is sucient just to lift them; to lower them, on the other hand,
you must operate the lever:
W
If the saddle position is too high or too low, this could result in incorrect leg movement.
To adjust the pedal straps, insert the tip of the foot into the toe clip (D) and move the front of
the foot beyond the pedal axis; tighten the buckles on the straps (E) so that the foot is properly
inserted and held by the toe clip (D).
Move the tip of the foot and the knees forwards to ensure maximum pedal eciency.