12 Switching on and o
To turn the equipment on, switch the main switch to the “I” position (on) .
After a quick system check (reset), the equipment is ready for use.
To turn the equipment o, switch the main switch to the “0” position (o).
The equipment must be switched o only at the end of the exercise, when in
standby.
If the equipment is not expected to be used for a long time, as well as turning
it o you should also pull the plug out of the wall socket.
Warning
The switch is for turning the equipment on and o but does not isolate
it completely from the mains voltage, even in the “0” position (o). For
complete isolation you must unplug the power supply plug.
To Next Page
Loading...
