30
SKILLMILL
TROUBLESHOOTING
Below is a list of problems that may arise during normal use of the equipment. If the described remedies do not solve the problem, contact the Technical
Support Service.
Problem Cause Remedy
The display does not turn
on
Mains power failure.
Check the power supply in the mains socket in question
by plugging in another appliance that you are sure works
Power supply cable damaged. Contact the Technogym Technical Support Service.
The power supply cable is not correctly plugged in. Check the connection.
Installation problems with the power supply cable. Check the connection.
The control panel connector has been accidentally
disconnected.
Contact the Technogym Technical Support Service.
The battery is at. Charge the battery.
Too noisy
Equipment not properly levelled. Check the position and level with the adjustment screws.
Damaged bearings. Contact the Technogym Technical Support Service.
Rotating belt not centrally aligned. Contact the Technogym Technical Support Service.
To Next Page
Loading...
