Technogym SKILLRUN UNITY 5000 - Wireless Network Guidelines

SKILLRUN (DJJ) Pre-Installation Requirements
Rev. 2.0
- 22 -
NOTE: The Protocol WPA2 Enterprise is not supported.
_There must be only one dedicated Access Point / Wi-Fi router that provides the service;
_ DHCP enabled;
In case of professional Access Point or if the equipment is used in a public / company network
(hotel, tness facility) you must cover the following additional requirements:
_Congure the Access Point to broadcast only one SSID (Service Set Identier) needed for the
equipment installation. The SSID must not be hidden;
_Program in the display of equipment (Customer Menu 2406: Network: Wi-Fi) just only the SSID
dened above;
_ Frequency Band:
▪ 5GHz band only (not automatic) is the conguration suggested;
▪ If the Access Point is not provided with 5GHz band, 2.4GHz is ok but might need some chan-
nel ne tuning by the local IT company. The best practice for 2.4GHz Wi-Fi conguration is
enabling Wi-Fi on one of the following channels: 1, 6, 7, 8, 9, 10, 11, 12. Other channels: 2,
3, 4, 13, 14 might cause interference with Bluetooth signal.
▪ Avoid in any case to broadcast the same SSID through 2.4 and 5 GHz at the same time.
_ LEASE TIME : at least three days;
_ SESSION TIMEOUT disabled (Typically achieved setting the timeout = 0).
For more details about Access Point, refer to the AP technical specications.
5.5 WIRELESS GUIDELINES
The following indications must be interpreted only as guidelines.
The wireless network must be installed and congured only by specialised companies and expert
technicians.
_The equipment must not be more than 25-30 metres LOS (line of sight) away from the Access
Point (analyse possible problems due to the presence of walls or other obstacles between the Ac-
cess Point and the equipment).
_If you use an Access Point with a xed channel: avoid overlapping problems if, in the same area,
there are Access Points that use the same channel.