Synchro Excite
25
Troubleshooting
Below is a list of problems that may arise during normal use of the equipment. If the described remedies do not solve the problem, contact the Technical
Support Service. f
Problem Cause Remedy
Equipment doesn’t switch
on
Mains power failure (mains powered version).
Check the power supply at the wall socket used by the
equipment by plugging in an appliance that denitely
works.
Power supply cable damaged (mains powered version).
Contact the Technogym Technical Support Service.
Installation problems with the power supply cable (mains
powered version).
Check the connection.
Burnt-out fuses (mains powered version).
To replace the blown fuse with a spare contact Technogym
Technical Support Service.
The control panel connector has been accidentally
disconnected.
Contact the Technogym Technical Support Service.
Too noisy
Equipment not properly levelled. Check the position and level the adjustment feet.
Damaged bearings. Contact the Technogym Technical Support Service.
Worn belt. Contact the Technogym Technical Support Service.
Data incorrect or unreliable
with equipment running
Equipment next to source of radio interference (e.g.
electrical domestic appliances).
Move the equipment to another place or move the
domestic appliances.
To Next Page
Loading...
