TECHNOLOG Cello 4S - Typical installation: Boundary box, meter pit, vault or similar

C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 9 of 43
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: techsupport@technolog.com
www.technolog.com
DMR No.: 7504
2099PM9000 Rev. B
Typical installation: Boundary box, meter pit, vault or similar
The lid of the Cello 4S enclosure is designed to allow it to be fitted in the rim of typical 'boundary' type boxes.
Notes
In order to allow fitment of Cello 4S, the rim of the boundary box must be at least 135mm wide with a central orifice of
not less than 130mm and there must be not less than 30mm between the top edge of the rim and the underside of the
boundary box lid.
To maximise the remote communications signal strength, the unit should be positioned as high up as possible and,
where practical, away from metal structures.
However the unit should also be positioned such that exposure of users and / or bystanders to the potentially
dangerous radio frequencies ('RF') generated by the equipment are kept below recommended levels - for further
details refer to Technolog Declaration of Conformity ('D of C') document 2099DC9000 associated with the Cello 4S,
as well as the "RF exposure onsiderations" part of the "Standard connections - Port 5: External antenna connection"
section of this document.
•
•
•