Page 10 of 22
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail: info@technomark-marking.com
Maintenance operations to be carried out
-Check the general condition of the machine and the impact unit in particular. Clean the internal
components of the impact unit (core, stylus, guide) and lubricate the stylus.
-Clean the guides and internal parts of the machine. Use, as a minimum, a damp rag and, if possible,
a (dry) air blow gun.
-Check the condition of the marking head cable visually.
-Check the length of the spring (see chapter 5.2).
-Check the tip of the stylus. This may affect the quality of the marking. If chipped or rounded,
sharpen the tip or change the stylus (see chapter 5.1).
-Check the clearance between the guide and the stylus (see illustration 7). If the clearance is too
great, change the stylus guide.
-Check (always with the control unit disconnected) that the axes of the X/Y have no hard points. To
do this, move the internal part of the machine, using the guides for grip.
DO NOT MOVE BY PUSHING THE IMPACT UNIT
-Ask the TECHNOMARK team, or an authorised dealer, to service the machine.
This service will include:
Changing all the bushings and joints.
Full cleaning of the machine and its guidance elements.
Checking the condition and operation of all the machine’s electronic elements and cables.
Testing the operation of the impact unit.
Full test of the machine, as on the day it left the factory.
Should a fault be detected on the marking head, the defective part will be replaced.
The spline shaft and ball bearing must not be lubricated with Vaseline oil. The spline shaft has a self-
lubricating coating, which can be affected by the use of such oils.
When using your machine, you may notice a black deposit coming from the spline shaft. This is normal and
To Next Page
Loading...
