To Next PageTo Next PageWhat to do if Technomark M4 inline displays error code 65?
If the Technomark Label Maker displays error code 65, related to an error in the IDI calibration function, check the stylus/part distances. Also, inspect the condition of the striker unit and stylus; clean and lubricate the stylus. Then, restart an IDI calibration, ensuring it's the only menu open.
What to do if Technomark M4 inline Label Maker displays error code 13?
If the Technomark Label Maker shows error code 13, it means there's no marking head detected. Ensure the head is correctly connected and the connector is locked, then restart the controller. Inspect the cable's condition. Also, check for any obstructions blocking the striker unit's path and restart the controller. If needed, power off the device and manually check if the machine can move to its original position freely.
What to do if Technomark M4 inline displays error code 9?
If the Technomark Label Maker displays error code 9, it signifies an open circuit. You should check the condition of the striker unit cable, ensuring it is not cut or damaged, and then restart the controller. Also, inspect the striker unit connector to confirm it is undamaged and properly connected before restarting the controller. Additionally, verify the condition of the marking head cable and restart the controller.
What to do if Technomark M4 inline Label Maker displays error code 10?
If the Technomark Label Maker displays error code 10, which indicates a weak current, check the condition of the striker unit cable and restart the controller. Also, inspect the striker unit connector, ensuring it's properly connected, and then restart the controller.
What to do if Technomark Label Maker shows error codes 43, 44, 45, 46?
If the Technomark Label Maker gives error codes 43, 44, 45, or 46 related to USB stick errors, try using a different USB stick. If that doesn't work, restart the controller.
What to do if Technomark Label Maker displays error code 51?
If the Technomark Label Maker displays error code 51, indicating that it's marking busy, wait for the current task to finish or stop it.
How to fix matrix error on Technomark M4 inline?
If the Technomark Label Maker displays error code 4, a matrix error, change the matrix of the text.
What to do if Technomark M4 inline displays error code 49?
If the Technomark Label Maker shows error code 49, a window error, check the marking overview for any flags indicating marking outside of the window and reposition the text.
What to do if Technomark M4 inline displays error code 12?
If the Technomark Label Maker shows error code 12, which indicates an abandonment error, it means the current marking operation was interrupted. Restart the marking process and check at which point it was interrupted.
What to do if Technomark M4 inline Label Maker displays error 50?
If the Technomark Label Maker shows error code 50, a temperature error, turn the controller off for about ten minutes, then restart it. If the issue persists, try reducing the number of impacts by using a different font, reducing the marking speed, or reducing the marking force.
General| Brand | Technomark |
|---|---|
| Model | M4 inline |
| Category | Label Maker |
| Language | English |
